How 8Hubs Monitors Airport Status

8Hubs is an independent monitor of airport operating conditions. This page explains how it decides whether an airport is shown as open, disrupted, closed or unknown, what its figures mean and where its limits are.

What 8Hubs Monitors

8Hubs currently monitors 29 airports across the Middle East & Europe (21 in Middle East, 8 in Europe). For each airport it checks up to three public sources:

The system can use a commercial flight-data feed, but none is currently enabled, so every figure comes from the page checks described below. Each airport page lists its sources, how they relate to the airport and how they responded in the latest check.

How a Check Works

Each source is opened in a real (headless) web browser, so pages built with JavaScript are read as a visitor would see them, including content inside embedded frames. The visible text is then scanned for the words and phrases listed on this page. Pages are not parsed flight by flight.

A new check cycle is scheduled every 5 minutes; a cycle starts only after the previous one has finished, and a single airport's check is abandoned if it takes longer than 240 seconds. The exact time of each airport's latest check is shown on its page.

What the Arrival, Departure, Delay and Cancellation Figures Mean

The figures are signals: the number of times certain status words appear on the airport's flight-information page in the latest check. They are not flight totals and do not cover a fixed time window. Each figure is capped at 60.

Words such as "on time", "scheduled" and "boarding" count towards both arrival and departure signals, and words in page menus or headings (for example an "Arrivals" tab) are counted too. A large airport can therefore show small numbers when its page shows few rows, and 0 means none of those words were found, not necessarily that no flights operated. When the flight-information page could not be read in a recent check, the figures are shown as "Not available" rather than 0.

What Each Status Means

Movement signals are arrival signals plus departure signals. The rules are applied in this order:

  1. Unknown (confidence 20%) – the flight-information page returned no readable content, so there is no evidence to classify.
  2. Closed (confidence 90%) – the aviation authority's site contains a closure phrase and no movement signals were found. Closure phrases: "airport closed", "operations suspended", "suspended until", "closed until further notice", "airspace closed", "grounded all flights", "no flights operating", "airport is closed".
  3. Unknown (confidence 40%) – a closure phrase was found but movement signals were also found; the evidence conflicts.
  4. Disrupted (confidence 75% when all three sources were readable, otherwise 60%) – the authority's site contains a disruption phrase, or movement signals were found together with delay or cancellation signals. Disruption phrases: "operational disruption", "limited operations", "reduced capacity", "restricted operations", "partial suspension", "flights disrupted".
  5. Open (confidence 90%) – movement signals were found, with no delay, cancellation, disruption or closure signal, and all three sources were readable.
  6. Open (confidence 65%) – the same, but not every source could be read.
  7. Unknown (confidence 30%) – no movement signals and no notices.

Open means movement was detected and nothing indicating disruption was found; it does not mean every flight is on time. Disrupted means flights are still moving but with problems; it does not mean closed. Closed is used only with a closure phrase and no detected movement; an unreachable website is never treated as a closure.

A change between Open and Disrupted is applied only when two consecutive checks agree, so a single word appearing or disappearing on a flight page does not make the status flip back and forth; until then the previous status and its figures are kept. Closed, Unknown and manual changes are applied immediately.

If a check fails or produces Unknown while the airport already has a confirmed status, the previous status is kept rather than replaced, the last-check time still updates and source health shows the failure. If an airport has never had a confirmed status and its check fails, it is shown as Unknown. An unexpected processing error marks the airport Unknown. An operator can set a status manually for a limited time; this is labelled "set manually" and carries 100% confidence.

Disruption Severity

For a disrupted airport, severity is the share of affected signals: (delay signals + cancellation signals) divided by movement signals. 50% or more is severe, 15% or more is moderate and anything lower is minor. If no movement signals were found (for example a disruption notice on its own), severity is not rated.

Confidence

Each classification carries the confidence listed in the rules above. 85% and higher is shown as high, 60% to 84% as medium and below 60% as low.

Source Health

Health always refers to the latest check attempt.

Freshness

Every page shows when the airport data was last checked and, where known, when its status last changed. If the latest check is more than 2 hours old, the page says so and signals are shown as "Not available". Timestamps come from the monitoring system, never from the time a page is viewed.

Monitoring Gaps

Monitoring has not always been continuous. No observations exist from 16 Sep 2026, 17:10 UTC to 3 Oct 2026, 21:42 UTC. Periods without observations are treated as unknown, never as normal operation, and are excluded from history calculations.

Limitations

About 8Hubs · Live airport status